How do you convert absorbance to transmittance?
Raise 10 to the negative absorbance to get fractional transmittance. Multiply the fraction by 100 for percent transmittance. An absorbance of 2 gives a fraction of 0.01, so 1% of the incident light passes through. Every increase of 1 in absorbance divides transmittance by 10.
Fractional transmittance T = 10−A. Percent transmittance = 100 × T.
How do you calculate absorbance from percent transmittance?
Divide the percentage by 100, then take the negative base-10 logarithm. For example, 25% means a fraction of 0.25 and absorbance of about 0.60206. If your reading is already a fraction, use it directly.
Absorbance A = −log10(T) = −log10(%T ÷ 100).
How do you calculate absorbance from measured light power?
Divide transmitted power by incident or reference power. Use the same units, wavelength and measurement setup. For 100 µW transmitted out of 400 µW incident, the fraction is 0.25, the percent is 25%, and absorbance is about 0.60206. The IUPAC analytical spectroscopy recommendations specify the power ratio and the base-10 form of absorbance.
What do zero and negative readings mean?
At 100% transmittance, absorbance is zero. At exactly zero transmittance, there is no finite absorbance. A negative absorbance can occur when a measured sample transmits more than its reference. This calculator covers passive attenuation with 0–300 absorbance and positive transmittance up to 100%. Check the reference and measurement method if you see values outside that range.
Absorbance and percent absorbed
Absorbance is a logarithm. Percent transmittance describes how much light reaches the detector. The difference from 100% can include reflection and scattering as well as absorption. This conversion alone cannot determine concentration, isolate those losses, or establish the suitability of laser safety equipment.