Baking Pan Conversion Calculator

About this calculator

Compare the original and target baking pans to find how much batter to make. Choose the same batter depth or enter a different depth for each pan.

Example: an 8-inch round pan to a 9-inch round pan.

Original pan

Enter all measurements for this pan in inches.

Target pan

Enter all measurements for this pan in inches.

Use inside measurements. The factor is based on area at the same depth or batter volume at entered depths.

Embed this calculator

Paste this code into a Custom HTML block on your site. The calculator fits the width of the block. Adjust the height in the code if you want more room for results.

Find this widget in the publisher directory

How to convert baking pan sizes

Measure the inside dimensions of each pan. This calculator uses straight-wall geometry for round, square, rectangular and ring pans. For a group of identical pans, multiply the area of one pan by the count.

Same batter depth: recipe multiplier = target total base area ÷ original total base area.

Entered batter depths: recipe multiplier = (target total base area × target depth) ÷ (original total base area × original depth).

A round pan has base area π × diameter² ÷ 4. For a straight ring pan, subtract the inner circle from the outer circle. For a rectangular pan, multiply inside length by inside width. The calculator converts entered dimensions to centimeters before comparing areas. A cubic centimeter is one milliliter.

Convert an 8-inch round cake pan to 9 inches

At the same depth, the factor is 9² ÷ 8² = 1.265625. An original 800 g batch scales to about 1,013 g. Multiply each ingredient by that factor if you are scaling the entire recipe.

Why wall height and batter depth are different

Wall height determines the geometric brim volume of a straight-wall pan. It does not change the amount of batter needed for the same depth. If a 9-inch target pan is twice as tall as the original, the same-depth factor is still 1.265625 for the 8-to-9-inch example.

When you enter actual or intended batter depths, the result also shows how deep the whole original batch would be in the target pans. Use this comparison to decide whether you want the same batch, a smaller batch or additional pans. Geometric space above the batter describes the space before rise.

Which pans fit the straight-wall estimate?

Use the result for pans with approximately straight sides and a consistent cross-section. Sloped loaf pans, rounded corners and decorated Bundt pans can differ from their nominal dimensions. Two pans of the same size can differ in material, color and heat behavior. Follow the recipe for how full to fill the pan and how to check doneness.

For practical pan comparisons and baking considerations, see King Arthur Baking’s pan substitution guide. To compare flour and other ingredients by weight, use the Baker’s Percentage Calculator.

If you’re also switching to convection bake, the Convection Oven Conversion Calculator shows which temperature to enter based on your oven’s automatic setting.

Frequently asked questions

Can I convert between round and square cake pans?
Yes. Use the inside diameter of the round pan and the inside side length of the square pan. At the same batter depth, divide the target base area by the original base area.
Can I use centimeters for one pan and inches for the other?
Yes. Select a separate unit for each group. Use that unit for all dimensions and depths within the group.
Does a taller pan need more batter?
A taller straight-wall pan has more brim capacity. The batter amount stays the same if base area and intended batter depth stay the same.
Does the conversion tell me how long to bake?
It compares batter geometry. Use recipe guidance and check doneness for the actual pan and batter.

Formulas and sample results on this page were checked against independent references. Page last reviewed or updated . How we verify calculators. Project led by Shaun Connell.