Measured Step Response Calculator

About this calculator

Open a CSV or paste recorded time and response values. The calculator finds the observed overshoot, the 10–90% transition time and the duration of the final in-band sample window.

Load your samples

Open a UTF-8 CSV or paste comma- or tab-separated columns from a spreadsheet. Use up to 2,000 sample rows, with an optional header row. Your data stays in this tab.

Set the reference and capture rules

Enter the starting timestamp in the selected time unit. Results show elapsed time from that point.

Use the baseline before the step and a final reference you know or choose. The last sample is shown separately.

Enter both durations in the selected time unit to check whether the capture meets your hold and sampling requirements.

Embed this calculator

Paste this code into a Custom HTML block on your site. The calculator fits the width of the block. Adjust the height in the code if you want more room for results.

Find this widget in the publisher directory

How to use a recorded step response

Use a time column and a measured output column from a CSV or spreadsheet. If your file has sensor readings and command signals, choose the sensor column for the response. Check the first three readings before calculating. Enter the original time unit and select the starting timestamp of the part you want to examine. Results use elapsed time from that point.

Enter the pre-step baseline as the initial output and the value you want to assess as the final reference. For example, when a process moves from 100 toward a target of 80, enter 100 and 80. If you choose the last sample as the reference, the results describe the response relative to that choice. The calculator always prints the final measured output separately.

How do you calculate overshoot on a falling step?

Divide each sample's change from the initial output by the signed difference between the final and initial references. That normalized response moves toward 1 for either an increase or a decrease. Find the largest recorded normalized value and subtract 1. Multiply the positive excess by 100.

z = (output − initial) ÷ (reference − initial). Overshoot = 100 × max(0, max(z) − 1).

For a step from 100 toward 80, a recorded low of 75 is 5 units beyond the reference on a 20-unit step. Its observed overshoot is 25%. The farthest sample in the step direction is a minimum for a falling step. It is a maximum for a rising step.

How are transition time and the settling band measured?

The 10–90% transition time is the difference between the first observed crossings of the two normalized thresholds after your analysis start. With adjacent readings on opposite sides of a threshold, the calculator uses straight-line interpolation. If a threshold crossing is already past, outside the recording or across a gap larger than your limit, the calculator explains why it cannot report a complete transition time.

The settling band is the final reference plus or minus the chosen percentage of the step size. The calculator finds the final out-of-band observation and checks the run of in-band samples that follows it. Enter a planned hold and a maximum sample gap to evaluate that run. A capture ending two seconds after first entering the band cannot demonstrate a three-second hold. Return to the acquisition and capture a longer window when the result is needed.

These are measurements of the supplied samples. A peak or out-of-band excursion could fall between observations. A short recording cannot establish what happens later. You can compare common thresholds with the MathWorks sampled step response reference. Its mode and reference choices may differ.

What can I import?

Use 4–2,000 sample rows with 2–32 columns and an optional header. Timestamps must rise strictly. The import accepts rectangular CSV or tab-separated text. For a file that includes a separate units row or equipment settings before the header, copy the time and response columns into the paste box and choose their time unit. This browser tab keeps your working values in memory. Clear or close the tab to discard them.

Formulas and sample results on this page were checked against independent references. Page last reviewed or updated . How we verify calculators. Project led by Shaun Connell.