Drawing Scale Calculator

About this calculator

Convert plan or model lengths, check the scale of a print, or find the percentage for resizing to a new scale.

Enter 1:50, or use named units such as 1/8 in = 1 ft. The drawing measurement comes first.

Embed this calculator

Paste this code into a Custom HTML block on your site. The calculator fits the width of the block. Adjust the height in the code if you want more room for results.

Find this widget in the publisher directory

How to convert a drawing length to an actual length

A drawing scale compares a length on paper or in a model with the corresponding actual length. In a ratio such as 1:50, one drawing unit represents 50 of the same real-world units. The University of Arizona Libraries map scale guide calls this a representative fraction and explains why both sides use the same unit.

Actual length = drawing length ÷ drawing-to-real fraction. Drawing length = actual length × drawing-to-real fraction.

For example, 3.5 cm on a 1:50 plan represents 175 cm, or 1.75 m. To calculate an enlargement such as 2:1, put the drawing side first in the same way.

How to use an architectural scale such as 1/8 inch per foot

Enter an equality with units, such as 1/8 in = 1 ft or 1/8″ = 1′-0″. A foot equals 12 inches, so the drawing-to-real ratio is (1/8) ÷ 12 = 1:96. The worksheet also accepts fractions and mixed numbers for lengths, such as 1 1/4 inches.

How to find scale from a measured print

Measure one line on the print and enter the actual length of the same line, using a labeled dimension or another verified source. Divide the measured length by the actual length in the same units. If 1 1/4 in on paper represents 10 ft, the ratio is 1:96.

Print settings or scanning can change the scale printed in a title block. Compare a second known dimension, ideally in a perpendicular direction, if the print may have stretched unevenly.

How to resize a drawing from one scale to another

Divide the target drawing-to-real fraction by the original drawing-to-real fraction. Multiply by 100 to get the percentage of the current drawing length. Going from 1:100 to 1:50 uses 200%. Going back uses 50%. The Archtoolbox drawing scale guide applies the same comparison to architectural and engineering scales.

Print percentage = (target scale fraction ÷ current scale fraction) × 100.

Check the print dialog for any automatic fit setting and verify a known dimension on the result. This calculation gives a linear scale change for a drawing, model or map at a known scale.

Frequently asked questions

What does 1:100 mean?
One unit on the drawing corresponds to 100 of the same units in the actual object. A 2 cm line represents 2 m.
Is 1/8 inch to 1 foot the same as 1:8?
No. A foot is 12 inches, so an eighth inch to a foot is 1:96.
Can I use inches for the drawing and meters for the actual length?
Yes. Select each unit independently. A drawing-to-real ratio uses consistent units internally.
Does 200% mean add 200% to the size?
Set the resulting print to 200% of the current size. This doubles its linear dimensions.

Formulas and sample results on this page were checked against independent references. Page last reviewed or updated . How we verify calculators. Project led by Shaun Connell.