Drawer Front Layout Calculator

About this calculator

Size all the inset drawer fronts in one finished opening. Keep any front at a fixed height and split the remaining space between the others. Get a cut list and mark every edge from the top of the opening.

Changing the unit uses the same numbers in the new unit.
Enter a decimal or fraction for a fixed height, or type auto. Up to 12 fronts.
Leave blank for exact dimensions, or enter the smallest cut increment you can use.
Embed this calculator

Paste this code into a Custom HTML block on your site. The calculator fits the width of the block. Adjust the height in the code if you want more room for results.

Find this widget in the publisher directory

Start from the finished opening

Measure between the finished cabinet surfaces that surround the inset fronts. Use one unit throughout. The reveal is the visible space beside a front. Enter the left, right, top and bottom reveals separately, and enter one common gap between adjacent fronts. The tool assumes one rectangular opening with no rails between fronts.

Keep a shallow top drawer at a fixed height

For a 24 × 30 inch opening, enter 1/8 inch on the left, right and top, 3/16 inch at the bottom and 1/8 inch between fronts. Enter 5 1/4, auto and auto on separate lines. The finished width is 23 3/4 inches. The two lower fronts share 24 3/16 inches, so without a cut increment each is exactly 12 3/32 inches high.

With a 1/16-inch cut increment, the two lower fronts become 12 1/8 and 12 1/16 inches. The fixed top is still 5 1/4 inches. The last bottom edge is 29 13/16 inches from the top, leaving precisely the 3/16-inch bottom reveal.

How the cut list preserves the opening

Finished front width equals opening width minus the two side reveals. The available front height equals opening height minus the top and bottom reveals and all between-front gaps. After subtracting fixed heights, the exact plan divides the remaining height equally across the automatic rows.

If you enter a cut increment, the width, fixed heights and total remaining height must fit that increment exactly. Automatic fronts get equal whole increments first. Any leftover increments go one at a time to the first automatic rows. This keeps the total exact and changes a flexible front by no more than one increment compared with another. The marks use the resulting sizes and the exact entered gaps. A mark can still fall between ticks on your tape if the reveal or gap itself is off-grid.

Use edge marks from one reference

Measure each displayed top or bottom edge from the top of the opening. That keeps small layout errors from accumulating as you move down the stack. Check the opening for square and check the physical front, slides, pull clearances and finish build-up before cutting. The calculator sizes visible inset fronts. It does not size drawer boxes, select hardware or plan overlay fronts.

For manufacturer-specific measuring instructions, consult the Hampton Bay measuring guide or the instructions for the product you are ordering.

Frequently asked questions

Can I use different heights for the drawer fronts?
Yes. Enter a fixed height for any front and type auto on the rows that should share the remaining space.
Why can’t the calculator use my cut increment?
The cut increment must fit the finished front width, each fixed front and the total automatic height. If those values do not fit, choose a finer increment or clear the field to see the exact plan.
What is the difference between drawer front height and drawer box height?
Front height is the finished visible face. Box height depends on the cabinet, the slide hardware and clearance behind the face.

Formulas and sample results on this page were checked against independent references. Page last reviewed or updated . How we verify calculators. Project led by Shaun Connell.